White Papers

In order that settings corresponding to the neighbor send-community command take effect, you
must execute the clear ip bgp command immediately after you execute the neighbor send-
community command.
If you do not set any of the optional parameters (standard or extended), then both standard as well as
extended attributes are sent. If you set either the standard or extended parameter, only the attribute that
is specified is sent.
neighbor shutdown
Disable a BGP neighbor or peer group.
Syntax
neighbor {ip-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the neighbor {ip-address | peer-group-
name}no shutdown command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to disable or enable all routers within the peer
group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
Peers that are enabled within a peer group are disabled when their peer group is disabled.
The neighbor shutdown command terminates all BGP sessions on the BGP neighbor or BGP peer
group. Use this command with caution as it terminates the specified BGP sessions. When a neighbor or
peer group is shut down, use the show ip bgp summary command to confirm its status.
Related
Commands
● show ip bgp summary — display the current BGP configuration.
● show ip bgp neighbors — display the current BGP neighbors.
Border Gateway Protocol 395