White Papers

● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port/subport information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
Defaults Disabled.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results. This
command displays packets for IGMP and IGMP snooping.
ip igmp access-group
To specify access control for packets, use this feature.
Syntax
ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list command.
632 Internet Group Management Protocol (IGMP)