White Papers

Layer 2
Overhead
Link MTU and IP MTU Delta
Tagged Packet
with VLAN-Stack
Header
26 bytes
negotiation auto
Enable auto-negotiation on an interface.
Syntax
negotiation auto
To disable auto-negotiation, use the no negotiation auto command.
Defaults Enabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.0 Introduced on the E-Series.
Usage
Information
This command is supported on 10/100/1000 Base-T Ethernet interfaces.
You can use the negotiation auto command on the 10G ports on the device.
The no negotiation auto command is only available if you first manually set the speed of a port to
10Mbits or 100Mbits.
The negotiation auto command provides a mode option for configuring an individual port to forced-
master/forced slave after you enable auto-negotiation.
If you do not use the mode option, the default setting is slave. If you do not configure forced-master or
forced-slave on a port, the port negotiates to either a master or a slave state. Port status is one of the
following:
688 Interfaces