White Papers

hello
Configure the rate at which the LLDP control packets are sent to its peer.
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds Enter the rate, in seconds, at which the control packets are sent to its peer. The
rate is from 5 to 180 seconds. The default is 30 seconds.
Defaults 30 seconds
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
mode
To receive or transmit, set LLDP.
Syntax
mode {tx | rx}
To return to the default, use the no mode command.
Parameters
tx Enter the keyword tx to set the mode to transmit.
rx Enter the keyword rx to set the mode to receive.
942 Link Layer Discovery Protocol (LLDP)