Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1061

Table Of Contents

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series. Added support for Multi-Process OSPF.

7.5.1.0 Introduced on the C-Series.

pre- 6.1.1.1 Introduced on the E-Series.

Usage

Information

The Helper mode is enabled by default on the device. To enable the restart mode also on the device, you

must configure the grace period using this command. After you enable restart mode the router advertises

the neighbor as fully adjacent during a restart.

graceful-restart helper-reject

Specify the OSPF router to not act as a helper during graceful restart.

Syntax

graceful-restart helper-reject ip-address

To return to default value, use the no graceful-restart helper-reject command.

Parameters

ip-address

Enter the OSPF router-id, in IP address format, of the restart router that will not

act as a helper during graceful restart.

Defaults Not configured.

Command Modes ROUTER OSPF

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.