Administrator Guide

Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced on the S3048-ON, S4048–ON, S4048T-ON, S6000–ON, S6100–ON,
and Z9100–ON
Usage
Information
Once you enter reload-type, you need to enter the boot-type or secure-erase sub-command
required on the next reboot.
Example
DellEMC(conf)#reload-type
DellEMC(conf-reload-type)#boot-type fastboot
DellEMC(conf-reload-type)#end
Dell#
boot-type
Allows you to configure the boot-type for the next reload.
Syntax
boot-type bmp-reload| fastboot| normal-reload| warmboot
Parameters
bmp-reload Reloads using the bare metal provisioning mode
fastboot Reloads using the fastboot mode
normal-reload Reloads using the standard, manual interactive mode
warmboot Reloads using the warmboot mode
Defaults normal-reload
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced on the S3048-ON, S4048–ON, S4048T-ON, S6000–ON, S6100–ON,
and Z9100–ON
Usage
Information
Once you enter reload-type, you need to enter the boot-type required on the next reboot. After
configuring boot-type you need to save the configuration with the write cli to make it active.
Example
DellEMC(conf-reload-type)#boot-type warmboot
DellEMC(conf-reload-type)#end
Dell#
secure-erase
Allows you to perform an fstrim on the flash disk during the next reload.
Syntax
secure-erase
To disable secure-erase, use the no secure-erase command.
Defaults Enabled.
Command Modes CONFIGURATION
120 Control and Monitoring