Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

801

802

803

804

805

806

807

808

809

810

Table Of Contents

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.7.0 Introduced on the S4810.

8.4.2.1 Introduced on the S-Series.

8.2.1.0 Introduced on the E-Series.

7.8.1.0 Introduced on the C-Series.

7.4.1.0 Introduced on the E-Series. Added the monitor option.

permit

To configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or UDP.

Syntax

permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp}

To remove this filter, you have two choices:

● Use the no seq sequence-number command syntax if you know the filter’s sequence number

● Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} command

Parameters

ip-protocol-

number

Enter an IPv6 protocol number. The range is from 0 to 255.

icmp Enter the keyword icmp to filter internet Control Message Protocol version 6.

ipv6 Enter the keyword ipv6 to filter any internet Protocol version 6.

tcp Enter the keyword tcp to filter the Transmission Control protocol.

udp Enter the keyword udp to filter the User Datagram Protocol.

Defaults Not configured.

Command Modes ACCESS-LIST

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.