Administrator Guide

Parameters
access-list-name Enter the name of a configured access list, up to 140 characters.
in | out Enter either the keyword in or out to apply the IPv6 ACL to incoming traffic
(ingress) or outgoing traffic (egress).
implicit-permit (OPTIONAL) Enter the keywords implicit-permit to change the default
action of the IPv6 ACL from implicit-deny to implicit-permit (that is, if the traffic
does not match the filters in the IPv6 ACL, the traffic is permitted instead of
dropped).
vlan range (OPTIONAL) Enter the keyword vlan followed by the VLAN range in a comma
separated format. The range is 1 to 4094.
optimized (OPTIONAL) Enter the keyword optimized to enable ACL optimization
Defaults Disabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
8.4.2.1 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series. Increased the name string to accept up to 140
characters. Prior to version 7.8.1.0, names are up to 16 characters long.
7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
You can assign an IPv6 access group to a physical, LAG, or VLAN interface context.
Example
DellEMC(conf-if-te-1/1/1/1)#ipv6 access-group AclList1 in implicit-
permit vlan 10-20
DellEMC(conf-if-te-1/1/1/1)#show config
!
interface TenGigabitEthernet 1/1/1/1
no ip address
ipv6 access-group AclList1 in implicit-permit Vlan 10-20
no shutdown
DellEMC(conf-if-te-1/1/1/1)#
cam-acl-egress
Allocate space for IPv6 egress ACLs.
Syntax
cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
Parameters
default Use the default CAM profile settings, and set the CAM as follows:
● L2 ACL(l2acl): 1
● L3 ACL (ipv4acl: 1
● IPv6 L3 ACL (ipv6acl): 2
810 IPv6 Access Control Lists (IPv6 ACLs)