Administrator Guide

route prefixes are cleared from RTM
DellEMC(conf)#no ip unicast-host-route
show ip tcp initial-time
Displays the interval that you configured for the device to wait before the TCP connection is attempted to be established.
Syntax
show ip tcp initial-time
Command Modes
EXEC
EXEC Privilege
Command
History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.7(0.1) Introduced on the S3048-ON.
9.7(0.1) Introduced on the S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL platforms.
ip unreachables
Enable the generation of internet control message protocol (ICMP) unreachable messages.
S6000
Syntax
ip unreachables
To disable the generation of ICMP messages, use the no ip unreachables command.
Defaults Disabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
IPv4 Routing 763