White Papers

Related
Commands
● show spanning-tree pvst — views the PVST+ configuration.
tc-flush-standard
Enable the MAC address flushing after receiving every topology change notification.
S6000
Syntax
tc-flush-standard
To disable, use the no tc-flush-standard command.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced.
Usage
Information
By default, Dell EMC Networking OS implements an optimized flush mechanism for PVST+. This
implementation helps in flushing the MAC addresses only when necessary (and less often) allowing for
faster convergence during topology changes. However, if a standards-based flush mechanism is needed,
you can turn this knob command on to enable flushing MAC addresses after receiving every topology
change notification.
vlan bridge-priority
Set the PVST+ bridge-priority for a VLAN or a set of VLANs.
S6000
Syntax
vlan vlan-range bridge-priority value
1148 Per-VLAN Spanning Tree Plus (PVST+)