White Papers

passive-interface
Suppress routing updates on a specified interface.
S6000
Syntax
passive-interface interface
To delete a passive interface, use the no passive-interface interface command.
Parameters
interface Enter the following information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Port Channel interface, enter the keywords port-channel then a
number.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
Command Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage
Information
Although the passive interface does not send or receive routing updates, the network on that interface
still includes in RIP updates sent using other interfaces.
Related
Commands
● neighbor — enables RIP for a specified network.
● network — defines a neighbor.
Routing Information Protocol (RIP) 1227