White Papers

ManualsBrandsDell ManualsAccess PlatformsOS9

1301

Table Of Contents

To undo the configuration, enter the no rate-limit command.

Defaults 30 packets per minute.

Parameters

packet per

minute

Enter the number of packets that you want processed per minute. The range is

between 10 to 60 packets per minute.

Command Modes

● CONF-DYNAMIC-AUTH

Usage

Information

● Packets are dropped after number of packets reaches the configured rate-limit.

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

The following is a list of the Dell EMC Networking OS version history for this command.

Version Description

9.14(1.0) Introduced on the S4810 and S4820T.

9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000,

S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and

MXL.

replay-protection-window

Configure replay protection window period to drop the duplicate packets.

Syntax

replay-protection-window minutes

To undo the configuration, enter the no replay-protection-window command.

Defaults 5 Minutes.

Parameters

minutes

Enter the number of minutes to drop the packets. The range is from 1 to 10

minutes.

Command Modes

● CONF-DYNAMIC-AUTH

Usage

Information

● Duplicate packets are dropped within replay-protection-window period if packet has same source IP

address, source UDP port and identifier.