White Papers

Version Description
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S3100 series, S4048–ON, S4048–ON, S4810, S4820T, S5000,
S6000, S6000–ON, S6100–ON, the Configuration Terminal Batch mode on C9010,
Z9100–ON, and Z9500.
9.9(0.0) Introduced on the C9010.
Usage
Information
The dot1x profile command configures a dot1x profile to define a list of trusted supplicant MAC
addresses. Maximum number of dot1x profiles is limited to 10. This command launches dot1x profile mode
for entering profile related commands such as the mac command. The dot1x static-mab command
assigns the dot1x profile to an interface.
Use this command in Configuration Terminal Batch mode to configure the dot1x profile in a dual-homing
setup.
Related
Commands
● dot1x static-mab
● mac
dot1x static-mab
Enable static MAC authorization bypass (MAB) and configure static MAB profile to an interface.
Syntax
[no] dot1x static-mab profile profile-name
Parameters
profile profile-
name
Enter the keyword profile and the profile-name to configure the static MAB
profile name. The profile name length is limited to 32 characters.
Defaults Disabled.
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S3100 series, S4048–ON, S4048–ON, S4810, S4820T, S5000,
S6000, S6000–ON, S6100–ON, the Configuration Terminal Batch mode on C9010,
Z9100–ON, and Z9500.
9.9(0.0) Introduced on the C9010.
Usage
Information
The dot1x static-mab command enables static MAB (mac auth bypass) and configures the
associated profile on a dot1x interface. Static MAB bypasses the authentication server for the supplicant
MAC addresses configured in the associated profile.
Before you enable static MAB, you must do the following:
● Enable MAC authentication bypass on the port by configuring the dot1x mac-auth-bypass
command.
● Ensure that no configured profile exists at the time of configuring the static-mab command.
● Use this command in Interface Batch Mode to enable static MAB in a dual-homing setup.
Example
DellEMC(conf)#do show dot1x interface twentyFiveGigE 1/41
802.1x information on Tf 1/41:
----------------------------------------
Dot1x Status: Enable
802.1X 161