White Papers

ip ecmp-group
Enable and specify the maximum number of ecmp that the L3 CAM hold for a route, By default, when maximum paths are not
configured, the CAM can hold a maximum of 16 ecmp per route.
S6000
Syntax
ip ecmp-group {maximum-paths | {number} {path-fallback}
To negate a command, use the no ip ecmp-group maximum-paths {number} command.
Parameters
maximum-paths Specify the maximum number of ECMP for a route. The range is 2 to 64.
path-fallback Use the keywords path-fallback to enable this feature. If you enable the
feature, re-enter this keyword to disable the feature.
Defaults 16
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Usage
Information
You must save the new ECMP settings to the startup-config (write-mem) then reload the system for
the new settings to take effect.
Related
Commands
● show ip cam stack-unit – display content-addressable memory (CAM) entries for an S-Series switch.
ip ecmp weighted
Enables weighted ECMP calculations.
Syntax
ip ecmp weighted
To disable weighted ECMP calculations, enter the no ip ecmp weighted command.
Defaults N/A
Command Modes CONFIGURATION
Equal Cost Multi-Path (ECMP) 567