White Papers

Usage
Information
Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in the IGMP groups.
You may not use extended access lists with this command. When you configure a static SSM map and the
router cannot find any matching access lists, the router continues to accept (*,G) groups.
Related
Commands
● ip access-list standard — create a standard access list to filter based on IP address.
ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
S6000
Syntax
ip igmp version {2 | 3}
Parameters
2 Enter the number 2 to set the IGMP version number to IGMPv2.
3 Enter the number 3 to set the IGMP version number to IGMPv3.
Defaults 2 (IGMPv2)
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Changed the default IGMP from version 2 to version 3. Introduced on the S6000-
ON
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
622 Internet Group Management Protocol (IGMP)