White Papers

NOTE: You cannot apply dampening on an interface that is monitoring traffic for other interfaces.
Example
Related
Commands
● clear dampening — clear the dampening counters on all the interfaces or just the specified interface.
● show interfaces dampening — display interface dampening information.
default interface
Reset a physical interface to its factory default settings.
Syntax
default interface interface-type slot/port - range
Parameters
interface-type
slot/port
Enter the interface type and slot/port information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
range
● For non-ON platforms, you can specify multiple ports as slot/port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces interface-
type 1/1 - 4.
● For ON platforms, you can specify multiple ports as slot/port/[subport]
- slot/port/[subport]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1/1 - 1/1/4.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S3100 series.
9.9(0.0) Introduced on the S4810, S4820T, S3048-ON, S4048-ON, S5000, S6000, S6000–
ON, and Z9500.
Usage
Information
Use the default interface command to set a Gigabit Ethernet, 10- Gigabit Ethernet, or 40-Gigabit
Ethernet interface to its factory-default state. By default, a physical interface is disabled (shutdown) with
no assigned IP address or switchport (no ip address). This command removes all software settings and all
L3, VLAN, VXLAN, and port-channel configurations on a physical interface.
Example
Related
Commands
● show running-config – display the current configuration.
description
Assign a descriptive text string to the interface.
Syntax
description desc_text
To delete a description, use the no description command.
Parameters
desc_text Enter a text string up to 240 characters long.
Interfaces 641