White Papers

Related
Commands
● duplex (10/100 Interfaces) — configures duplex mode on physical interfaces.
● negotiation auto — enable or disable auto-negotiation on an interface.
speed (Management interface)
Set the speed for the Management interface.
Syntax
speed {10 | 100 | 1000 | auto}
To return to the default setting, use the no speed command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
100 Enter the keyword 100 to set the interface’s speed to 100 Mb/s.
1000 Enter the keyword 1000 to set the interface’s speed to 1000 Mb/s.
auto Enter the keyword auto to set the interface to auto-negotiate its speed.
Defaults auto
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
This command is found on the Management interface only.
When manually configuring the management port speed the user must consider and match the remote
device. It is highly recommended to use Auto-Negotiation for management ports.
Related
Commands
● interface ManagementEthernet — configure the Management port on the system (either the Primary
or Standby RPM).
● management route — configure a static route that points to the Management interface or a
forwarding router.
688 Interfaces