White Papers

destination-mac
address
Enter the keywords destination-mac then the MAC destination address in the
nn:nn:nn:nn:nn:nn format.
vlan vlan-id Enter the keywords vlan then the VLAN-id. The range is from 0 to 4094.
ether-type Enter the keywords ether-type in the XX:XX format.
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Increased the number of port channels to 4096.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Usage
Information
Because this command calculates based on a Layer 2 hash algorithm, use this command to display flows
for switched Layer 2 packets, not for routed packets (use the show ip flow command to display
routed packets).
The show port-channel-flow command returns the egress port identification in a given port-
channel if a valid flow is entered. A mismatched flow error occurs if MAC-based hashing is configured for
a Layer 2 interface and you are trying to display a Layer 3 flow.
The output displays three entries:
● Egress port for unfragmented packets.
● In the event of fragmented packets, the egress port of the first fragment.
● In the event of fragmented packets, the egress port of the subsequent fragments.
NOTE: In the show port channel flow command output, the egress port for an unknown
unicast, multicast, or broadcast traffic is not displayed.
The following example shows the
show port-channel-flow outgoing-port-channel number
incoming-interface interface source-mac address destination-mac address
● Load-balance is configured for MAC
● Load-balance is configured for IP 4-tuple/2-tuple
● A non-IP payload is going out of Layer 2 LAG interface that is a member of VLAN with an IP address
Example
ip http source-interface
Specify an interface as the source interface for HTTP connections.
Syntax
ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
700 Interfaces