White Papers

| source-dest-
mac ]
● dest-port-id — Use dest-port-id field in hash calculation.
● dest-module-id — Use dest-module-id field in hash calculation.
● vlan — Use vlan field in hash calculation .
● ethertype — Use Ethertype field in hash calculation.
● source-dest-mac — Use SMAC and DMAC fields in hash calculation.
tunnel [ ipv4-
over-ipv4 | ipv4-
over-gre-ipv4 |
mac-in-mac ]}
To use tunnel key fields in hash computation, enter the keyword tunnel then one
of the parameters:
● ipv4-over-ipv4 — Use ipv4-over-ipv4 field in hash calculation.
● ipv4-over-gre-ipv4 — Use ipv4-over-gre-ipv4 field in hash calculation.
● mac-in-mac — Use mac-in-mac field in hash calculation.
Defaults IP selection 5-tuples (source-ip dest-ip vlan protocol L4-source-port L4-dest-port).
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
management route
Configure a static route that points to the Management interface or a forwarding router.
S6000
Syntax
management route {ip-address mask | ipv6-address 1.1.1.1prefix-length}
{forwarding-router-address | managementethernet | fortyGigE | vlan |
tengigabitethernet }
To remove a static route, use the no management route command.
Parameters
ip-address mask Enter an IP address (dotted decimal format) and mask (/prefix format) of the
destination subnet.
ipv6-address
prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix format) of the
destination subnet. Enter the IPv6 address in the x:x:x:x::x format followed by the
prefix length in the /x format.
740 IPv4 Routing