White Papers

show ip route summary
View a table summarizing the IP routes in the switch.
S6000
Syntax
show ip route [vrf vrf-name] [summary]
Parameters
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to view information on
the IP routes corresponding to that VRF.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip route summary shown in the following example.
Column
Heading
Description
Route Source Identifies how the route is configured in Dell EMC Networking OS.
Active Routes Identifies the best route if a route is learned from two protocol sources.
Non-active
Routes
Identifies the back-up routes when a route is learned by two different protocols. If
the best route or active route goes down, the non-active route becomes the best
route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes are advertised, then
information on those routes is displayed.
758 IPv4 Routing