White Papers

Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added supported for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.2) Introduced on the Z9000.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
Usage
Information
The following describes the show isis database command shown in the following example.
Field Description
IS-IS Level-1/
Level-2 Link
State Database
Displays the IS-IS link state database for Level 1 or Level 2.
LSPID
Displays the LSP identifier.
The first six octets are the System ID of the originating router.
The first six octets are the System ID of the originating router. The next octet is
the pseudonode ID. If this byte is not zero, the LSP describes system links. If this
byte is zero (0), the LSP describes the state of the originating router.
The designated router for a LAN creates and floods a pseudonode LSP and
describes the attached systems.
The last octet is the LSP number. An LSP is divided into multiple LSP fragments if
there is more data than cannot fit in a single LSP. Each fragment has a unique LSP
number.
An * after the LSPID indicates that the system originates an LSP where this
command was issued.
LSP Seq Num This value is the sequence number for the LSP that allows other systems to
determine if they have received the latest information from the source.
LSP Checksum This is the checksum of the entire LSP packet.
LSP Holdtime This value is the amount of time, in seconds, that the LSP remains valid. A zero
holdtime indicates that this is a purged LSP and is being removed from the link
state database. A value between brackets indicates the duration that the purged
LSP stays in the database before being removed.
ATT This value represents the Attach bit. This value indicates that the router is a Level
1-2 router and can reach other areas. Level 1-only routers and Level 1-2 routers
that have lost connection to other Level 1-2 routers use the Attach bit to find the
closest Level 1-2 router. They install a default route to the closest Level 1-2 router.
836 Intermediate System to Intermediate System (IS-IS)