White Papers

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
6.2.1.1 Introduced
ip msdp peer
Configure an MSDP peer.
S6000
Syntax
ip msdp peer peer address [connect-source] [description] [sa-limit number]
To remove the MSDP peer, use the no ip msdp peer peer address [connect-source
interface] [description name] [sa-limit number] command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
connect-source
interface
Enter the keywords connect-source then one of the interfaces and slot/port or
number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
description name (OPTIONAL) Enter the keyword description then a description name (maximum 80
characters) to designate a description for the MSDP peer.
sa-limit number (OPTIONAL) Enter the maximum number of SA entries in SA-cache. The range is
from 1 to 100000. .
Defaults See Parameters .
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
916 Multicast Source Discovery Protocol (MSDP)