Administrator Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(config-ext-nacl)#show conf
!
ip access-list extended patches
Dell(config-ext-nacl)#
Common IP ACL Commands
The following commands are available within both IP ACL modes (Standard and Extended) and do not have mode-specific
options. When an ACL is created without a rule and then is applied to an interface, ACL behavior reflects an implicit permit.
The C9000 supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types section.
clear counters ip access-group
Erase all counters maintained for access lists.
C9000 Series
Syntax
clear counters ip access-group [access-list-name]
Parameters
access-list-name (OPTIONAL) Enter the name of a configured access-list, up to 140 characters.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increase the name string to accept up to 140 characters. Prior to 7.8.1.0, names
were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Access Control Lists (ACL) 219