Administrator Guide
copyDestFileName.4 s /home/myfilename
copyServerAddress.4 a 11.11.11.11
Copy a Binary File to the Startup-Configuration
To copy a binary file from the server to the startup-configuration on the Dell EMC Networking system via FTP, use the following
command.
● Copy a binary file from the server to the startup-configuration on the Dell EMC Networking system via FTP.
snmpset -v 2c -c public -m ./f10-copy-config.mib force10system-ip-address
copySrcFileType.index i 1 copySrcFileLocation.index i 4 copySrcFileName.index s filepath/
filename copyDestFileType.index i 3 copyServerAddress.index a server-ip-address
copyUserName.index s server-login-id copyUserPassword.index s server-login-password
> snmpset -v 2c -c private -m ./f10-copy-config.mib 10.10.10.10 copySrcFileType.10 i 1
copySrcFileLocation.10 i 4 copyDestFileType.10 i 3 copySrcFileName.10 s /home/myfilename
copyServerAddress.10 a 172.16.1.56 copyUserName.10 s mylogin copyUserPassword.10 s mypass
Additional MIB Objects to View Copy Statistics
Dell EMC Networking provides more MIB objects to view copy statistics, as shown in the following table.
Table 96. Additional MIB Objects for Copying Configuration Files via SNMP
MIB Object OID Values Description
copyState .1.3.6.1.4.1.6027.3.5.1.1.1.1.11
1= running
2 = successful
3 = failed
Specifies the state of the
copy operation.
copyTimeStarted .1.3.6.1.4.1.6027.3.5.1.1.1.1.12 Time value Specifies the point in the up-
time clock that the copy
operation started.
copyTimeCompleted .1.3.6.1.4.1.6027.3.5.1.1.1.1.13 Time value Specifies the point in the up-
time clock that the copy
operation completed.
copyFailCause .1.3.6.1.4.1.6027.3.5.1.1.1.1.14
1 = bad filename
2 = copy in progress
3 = disk full
4 = file exists
5 = file not found
6 = timeout
7 = unknown
Specifies the reason the copy
request failed.
copyEntryRowStatus .1.3.6.1.4.1.6027.3.5.1.1.1.1.15 Row status Specifies the state of the
copy operation. Uses
CreateAndGo when you are
performing the copy. The
state is set to active when
the copy is completed.
Obtaining a Value for MIB Objects
To obtain a value for any of the MIB objects, use the following command.
806
Simple Network Management Protocol (SNMP)