Administrator Guide

show config
Display the changes you made to the RIP configuration. The default values are not shown.
Syntax
show config
Command Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Example
DellEMC(conf-router_rip)# show config
!
router rip
network 172.31.0.0
passive-interface GigabitEthernet 1/1
DellEMC(conf-router_rip)#
show ip rip database
Display the routes that RIP learns. If the switch learned no RIP routes, no output is generated.
Syntax
show ip rip database [ip-address mask]
Parameters
ip-address (OPTIONAL) Specify an IP address in dotted decimal format to view RIP
information on that network only. If you enter an IP address, also enter a mask
for that IP address.
mask (OPTIONAL) Specify a mask, in /network format, for the IP address.
Routing Information Protocol (RIP) 1297