Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1521

Table Of Contents

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.7.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

Usage

Information

STP is not enabled when you enter SPANNING TREE mode. To enable STP globally on the switch, use the

no disable command from SPANNING TREE mode.

Example

DellEMC(conf)# protocol spanning-tree 0

DellEMC(config-stp)#

Commands

● disable — disables spanning tree group 0. To enable spanning tree group 0, use the no disable

command.

show config

Display the current configuration for the mode. Only non-default values display.

Syntax