Administrator Guide

Field Description
● ?? — the entry is suspect.
TTL Displays the amount of time until the entry ages out of the cache. For dynamically
learned entries only.
Type Displays IP as the type of entry.
Address Displays the IP addresses assigned to the host.
Example
DellEMC# show hosts
Default domain is not set
Name/address lookup uses static mappings
Name servers are not set
Host Flags TTL Type Address
-------- ----- ---- ---- -------
ks (perm, OK) - IP 2.2.2.2
4200-1 (perm, OK) - IP 192.68.69.2
1230-3 (perm, OK) - IP 192.68.99.2
ZZr (perm, OK) - IP 192.71.18.2
Z10-3 (perm, OK) - IP 192.71.23.1
DellEMC#
Related
Commands
● traceroute — view the DNS resolution.
● ip host — configure a host.
show ip cam stack-unit
Display CAM entries for a port-pipe of a stack-unit on a S-Series or Z-Series switch.
Syntax
show ip cam stack-unit {stack-unit-number} [port-set {pipe-number} | vrf
vrf-name {ip-address mask [longer-prefixes [ecmp-group detail]]}| ecmp-
group {detail | member-info [detail [group-index index-number]]}| summary]
Parameters
stack-unit-
number
Enter the stack-unit ID. The range is from 1 to 12.
port-set pipe-
number
Enter the keyword port-set then the number of the stack unit’s port-pipe. The
unit ID range is from 0 to 0.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to display CAM entries
corresponding to that VRF.
network mask
[longer-prefixes
[ecmp-group
detail]]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for that
route only. You can enter one of the following keywords to filter results.
● Enter the keyword longer-prefixes to view routes with a common prefix.
● Enter the keyword ecmp-group detail to view the ECMP group index.
ecmp-group
{detail | member-
info [detail
[group-index
index-number ]]}
(OPTIONAL) Enter the keyword ecmp-group then one of the following keywords
to filter results.
● Enter the keyword detail to view the ECMP group index.
● Enter the keyword member-info to view the member information for the
ECMP group.
● Enter the keyword member-info detail to view detailed ECMP
membership and n-hop information.
● Enter the keyword group-index then the index number to show ECMP
membership per group. The range is from 0 to 1022.
summary (OPTIONAL) Enter the keyword summary to view a table listing route prefixes and
the total number routes which can be entered in to CAM.
Command Modes
● EXEC
744 IPv4 Routing