Administrator Guide

key innerL3header udf-id 6 packetbase innerL3Header offset 0 length 2
DellEMC(conf-udf-tcam)#
7. Configure the match criteria for the packet type in which UDF offset bytes are parsed.
CONFIGURATION-UDF TCAM mode
match l2ethertype ipv4 ipprotocol value vlantag tagStatus
DellEMC(conf-udf-tcam)#match l2ethertype ipv4 ipprotocol 4 vlantag any
8. View the UDF TCAM configuration.
CONFIGURATION-UDF TCAM mode
show config
DellEMC(conf-udf-tcam)#show config
!
udf-tcam ipnip seq 1
match l2ethertype ipv4 ipprotocol 4 vlantag any
DellEMC(conf-udf-tcam)#
9. Create a UDF qualifier to assign values to UDF IDs.
CONFIGURATION-UDF TCAM mode
udf-qualifier-value name
DellEMC(conf-udf-tcam)# udf-qualifier-value ipnip_val1
10. Assign a value to a UDF ID.
CONFIGURATION-UDF-Qualifier-Value Profile mode
udf-id 1-12 value mask
DellEMC(conf-udf-tcam-qual-val)#udf-id 1 aa ff
11. Associate the UDF qualifier value with a UDF packet profile in an IP access list.
CONFIGURATION-STANDARD-ACCESS-LIST mode
CONFIGURATION-EXTENDED-ACCESS-LIST mode
permit ip {source mask | any | host ip-address} {destination mask | any | host ip-
address} udf-pkt-format name udf-qualifier-value name
DellEMC(config-ext-nacl)#permit ip any any udf-pkt-format ipinip udf-qualifier-value
ipnip_val1
12. View the UDF TCAM configuration.
CONFIGURATION-UDF TCAM mode
show config
DellEMC(config-ext-nacl)#show config
!
ip access-list extended aa
seq 5 permit ip any any udf-pkt-format ipnip udf-qualifier-value ipnip_val1
DellEMC(config-ext-nacl)#
Configuring IP Mirror Access Group
To configure an IP mirror access group on an interface, use the following commands:
1. Allocate CAM profile for IPv4 ACL.
CONFIGURATION mode
Access Control Lists (ACLs)
129