Administrator Guide

bgp confederation peers as-number [... as-number]
○ as-number: from 0 to 65535 (2 Byte) or from 1 to 4294967295 (4 Byte).
All Confederation routers must be either 4 Byte or 2 Byte. You cannot have a mix of router ASN support.
To view the configuration, use the show config command in CONFIGURATION ROUTER BGP mode.
Configuring a BGP VRF address family
To perform BGP configuration between two neighbors that must exchange IPv6 or IPv4 VRF information, use the following
commands.
Following are the steps to configure BGP VRF address-family between two peers.
● Configure a VRF routing table.
CONFIG mode
ip vrf vrf-name
For more information on VRF configuration, see Virtual Routing and Forwarding (VRF).
● Enter the router configuration mode and the AS number.
CONFIG mode
router bgp as-number
● Specify the IPv4 address family configuration.
CONFIG-ROUTER-BGP mode
address-family {ipv4 [multicast] | ipv6 unicast} vrf vrf-name
vrf vrf-name — Specifies the name of VRF instance associated with the IPv4 or IPv6 address-family configuration.
● Add the IP address of the neighbor in the specified AS to the IPv4 MBGP neighbor table.
CONFIG-ROUTER-BGP-AF mode
neighbor {ip-address | ipv6–address | peer-group-name} remote-as as-number
● Enable the neighbor.
CONFIG-ROUTER-BGP mode
neighbor ip-address no shutdown
● Specify the number of prefixes that can be received from a neighbor.
CONFIG-ROUTER-BGP-AF mode
neighbor {ip-address | ipv6–address | peer-group-name} maximum—prefix maximum [threshold]
[warning-only]as-number
The following are the sample steps performed to configure a VRF, and VRF address families for IPv4 (unicast and multicast) and
IPv6.
DellEMC(conf)# ip vrf vrf1
DellEMC(conf-vrf)# exit
DellEMC(conf)# router bgp 100
DellEMC(conf-router_bgp)# address-family ipv4 vrf vrf1
DellEMC(conf-router_bgp_af)# neighbor 50.0.0.2 remote-as 200
DellEMC(conf-router_bgp_af)# neighbor 50.0.0.2 maximum-prefix 10000 warning-only
DellEMC(conf-router_bgp_af)# neighbor 50.0.0.2 no shutdown
DellEMC(conf-router_bgp_af)# exit
DellEMC(conf-router_bgp)# address-family ipv6 unicast vrf vrf1
DellEMC(conf-router_bgpv6_af)# neighbor 50.0.0.2 activate
DellEMC(conf-router_bgpv6_af)# exit
DellEMC(conf-router_bgp)# address-family ipv4 multicast vrf vrf1
DellEMC(conf-router_bgpv6_af)# neighbor 50.0.0.2 activate
DellEMC(conf-router_bgp)# exit
Following is the output of show ip bgp vrf vrf1 summary command for the above configuration.
DellEMC#show ip bgp vrf vrf1 summary
BGP router identifier 1.1.1.1, local AS number 100
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
1 neighbor(s) using 16384 bytes of memory
Border Gateway Protocol (BGP)
217