Administrator Guide

Defaults none.
Command Modes ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced to all platforms.
Usage
Information
This command is either enabled or disabled. If no OSPF process is identified as the MIB manager, the first
OSPF process is used.
If an OSPF process has been selected, it must be disabled prior to assigning new process ID the MIB
responsibility.
network area
Define which interfaces run OSPF and the OSPF area for those interfaces.
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-id command.
Parameters
ip-address Specify a primary or secondary address in dotted decimal format. The primary
address is required before adding the secondary address.
mask Enter a network mask in /prefix format. (/x)
area-id Enter the OSPF area ID as either a decimal value or in a valid IP address. Decimal
value range is from 0 to 65535. IP address format is dotted decimal format
A.B.C.D.
NOTE: If the area ID is smaller than 65535, it is converted to a decimal value.
For example, if you use an area ID of 0.0.0.1, it is converted to 1.
Command Modes ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
Open Shortest Path First (OSPFv2 and OSPFv3) 1069