Administrator Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage
Information
If you delete all the network area commands for Area 0, the show ip ospf command output does not
list Area 0.
The following describes the show ip ospf command shown in the following example.
Line
Beginning
with
Description
“Routing
Process...”
Displays the OSPF process ID and the IP address associated with the process ID.
“Supports
only...”
Displays the number of Type of Service (TOS) rouse supported.
“SPF
schedule...”
Displays the delay and hold time configured for this process ID.
“Convergence
Level”
“Min LSA....” Displays the intervals set for LSA transmission and acceptance.
“Number of...” Displays the number and type of areas configured for this process ID.
Example
DellEMC# show ip ospf 10
Routing Process ospf 10 with ID 1.1.1.1 Virtual router default-vrf
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 0
Min LSA origination 0 msec, Min LSA arrival 1000 msec
Min LSA hold time 5000 msec, Max LSA wait time 5000 msec
Number of area in this router is 1, normal 1 stub 0 nssa 0
Area BACKBONE (0)
Number of interface in this area is 1
SPF algorithm executed 205 times
Area ranges are
DellEMC#
show ip ospf asbr
Display all autonomous system boundary router (ASBR) routers visible to OSPF.
Syntax
show ip ospf [process-id | vrf vrf-name] asbr
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered,
command applies only to the first OSPF process.
Defaults None
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Open Shortest Path First (OSPFv2 and OSPFv3) 1079