Administrator Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
For ETS functioning, first assign the etsacl space using the cam-acl command.
DellEMC(conf)#cam-acl l2acl 2 ipv4acl 0 ipv6acl 0 ipv4qos 2 l2qos 0 l2pt
0 ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1 iscsi 2
Related
Commands
● dcb <ets | pfc> enable — enable priority flow control or enhanced transmission selection on interface.
PFC Commands
The following PFC commands are supported on the Dell EMC Networking OS.
clear hardware pfc-nodrop-priority
Clear the drop statistics.
Syntax
clear hardware pfc-nodrop-priority l2-dlf drops stack-unit stack-unit-
number port-set port-pipe
Parameters
stack-unit stack-
unit-number
Enter the keywords stack-unit and the stack unit number.
port-set port-
pipe
Enter the keywords port-set and port-pipe number. The port-pipe number is 0.
Command Modes
EXEC
EXEC Privilege
Command
History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the C9010, S6000, S6000–ON, Z9100–ON and S6100–ON.
Related
Commands
pfc-nodrop-priority l2-dlf drop — configures to drop the unknown unicast packets flooding on lossless
priorities.
show hardware pfc-nodrop-priority — displays the packets drop count corresponding to the priority.
470 Data Center Bridging (DCB)