CLI Guide

Version Description
9.12(0.0) Introduced the seq option for the class-map on all the Dell EMC Networking OS
platforms.
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage
Information
To access this command, enter the class-map command. After the class map is identified, you can
configure the match criteria.
Use this command to match an IP class-map against a single VLAN ID .
Related
Commands
● class-map — identifies the class map.
match ip vrf
Uses a VRF as the match criterion for an L3 class map.
S4048–ON
Syntax
match ip vrf vrf-id
To remove VRF as the match criterion, use the no match ip vrf vrf-id command.
Parameters
vlan vlan-id Enter the keyword vrf and then the ID of the VRF. The range is from 1 to 511.
Defaults none
Command Modes CONF-CLASS-MAP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5.(0.1) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage
Information
To access this command, enter the class-map command. After the class map is identified, you can
configure the match criteria.
Use this command to match an IP class-map against a single VRF ID .
Related
Commands
● class-map — identifies the class map.
1306 Quality of Service (QoS)