CLI Guide

● All members must have the same link MTU value and the same IP MTU value.
● The port channel link MTU and IP MTU must be less than or equal to the link MTU and IP MTU values
configured on the channel members. For example, if the members have a link MTU of 2100 and an IP
MTU 2000, the port channel’s MTU values cannot be higher than 2100 for link MTU or 2000 bytes for
IP MTU.
VLANs:
● All members of a VLAN must have same IP MTU value.
● Members can have different Link MTU values. Tagged members must have a link MTU 4 bytes higher
than untagged members to account for the packet tag.
● The VLAN link MTU and IP MTU must be less than or equal to the link MTU and IP MTU values
configured on the VLAN members. For example, the VLAN contains tagged members with Link MTU
of 1522 and IP MTU of 1500 and untagged members with Link MTU of 1518 and IP MTU of 1500. The
VLAN’s Link MTU cannot be higher than 1518 bytes and its IP MTU cannot be higher than 1500 bytes.
The following shows the difference between Link MTU and IP MTU.
Layer 2
Overhead
Link MTU and IP MTU Delta
Ethernet
(untagged)
18 bytes
VLAN Tag 22 bytes
Untagged Packet
with VLAN-Stack
Header
22 bytes
Tagged Packet
with VLAN-Stack
Header
26 bytes
negotiation auto
Enable auto-negotiation on an interface.
Syntax
negotiation auto
To disable auto-negotiation, use the no negotiation auto command.
Defaults Enabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
Interfaces 705