Connectivity Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1641

Table Of Contents

multicast peer-routing timeout

To retain synced multicast routes or synced multicast outgoing interface (OIF) after a VLT peer node failure, configure the

timeout value for a VLT node.

Syntax

multicast peer-routing timeout value

To restore the default value, use the no multicast peer-routing timeout command.

Parameters

value

Enter the timeout value (in seconds). The range is from 1 to 1200. The default is

150.

Command Modes VLT DOMAIN (conf-vlt-domain)

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.12(1.0) Introduced on the S5048F–ON.

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-

Mux (PMUX) mode only.

9.2(0.2) Introduced on the Z9000, S4810, and S4820T.

9.0.2.0 Introduced on the S6000.

peer-link port-channel

Configure the specified port channel as the chassis interconnect trunk between VLT peers in the domain.

Syntax

peer-link port-channel port-channel-number {peer-down-vlan vlan id}

Parameters

port-channel-

number

Enter the port-channel number that acts as the interconnect trunk.

peer-down-vlan

vlan id

Enter the keywords peer-down-vlan then a VLAN ID to configure the VLAN

that the VLT peer link uses when the VLT peer is down.

Defaults Not configured.

Command Modes VLT DOMAIN