Deployment Guide

Creating a Route Map
Route maps, ACLs, and prefix lists are similar in composition because all three contain filters, but route map filters do not
contain the permit and deny actions found in ACLs and prefix lists.
Route map filters match certain routes and set or specific values.
To create a route map, use the following command.
● Create a route map and assign it a unique name. The optional permit and deny keywords are the actions of the route map.
CONFIGURATION mode
route-map map-name [permit | deny] [sequence-number]
The default is permit.
The optional seq keyword allows you to assign a sequence number to the route map instance.
The default action is permit and the default sequence number starts at 10. When you use the keyword deny in configuring a
route map, routes that meet the match filters are not redistributed.
To view the configuration, use the show config command in ROUTE-MAP mode.
DellEMC(config-route-map)#show config
!
route-map dilling permit 10
DellEMC(config-route-map)#
You can create multiple instances of this route map by using the sequence number option to place the route maps in the
correct order. Dell EMC Networking OS processes the route maps with the lowest sequence number first. When a configured
route map is applied to a command, such as redistribute, traffic passes through all instances of that route map until a
match is found. The following is an example with two instances of a route map.
The following example shows matching instances of a route-map.
DellEMC#show route-map
route-map zakho, permit, sequence 10
Match clauses:
Set clauses:
route-map zakho, permit, sequence 20
Match clauses:
interface TenGigabitEthernet 1/1/1/1
Set clauses:
tag 35
level stub-area
DellEMC#
To delete all instances of that route map, use the no route-map map-name command. To delete just one instance, add the
sequence number to the command syntax.
DellEMC(conf)#no route-map zakho 10
DellEMC(conf)#end
DellEMC#show route-map
route-map zakho, permit, sequence 20
Match clauses:
interface TenGigabitEthernet 1/1/1/1
Set clauses:
tag 35
level stub-area
DellEMC#
The following example shows a route map with multiple instances. The show config command displays only the configuration
of the current route map instance. To view all instances of a specific route map, use the show route-map command.
DellEMC#show route-map dilling
route-map dilling, permit, sequence 10
Match clauses:
Set clauses:
route-map dilling, permit, sequence 15
Match clauses:
interface Loopback 23
Access Control Lists (ACLs)
115