Install Guide

neighbor AAA no shutdown
neighbor 10.155.15.2 remote-as 32
neighbor 10.155.15.2 shutdown
DellEMC(conf-router_bgp)#neigh 10.155.15.2 filter-list 1 in
DellEMC(conf-router_bgp)#ex
DellEMC(conf)#ip as-path access-list Eagle
DellEMC(config-as-path)#deny 32$
DellEMC(config-as-path)#ex
DellEMC(conf)#router bgp 99
DellEMC(conf-router_bgp)#neighbor AAA filter-list Eagle in
DellEMC(conf-router_bgp)#show conf
!
router bgp 99
neighbor AAA peer-group
neighbor AAA filter-list Eaglein
neighbor AAA no shutdown
neighbor 10.155.15.2 remote-as 32
neighbor 10.155.15.2 filter-list 1 in
neighbor 10.155.15.2 shutdown
DellEMC(conf-router_bgp)#ex
DellEMC(conf)#ex
DellEMC#show ip as-path-access-lists
ip as-path access-list Eagle
deny 32$
DellEMC#
Filtering BGP Routes
Filtering routes allows you to implement BGP policies.
You can use either IP prefix lists, route maps, AS-PATH ACLs or IP community lists (using a route map) to control which routes
the BGP neighbor or peer group accepts and advertises. Prefix lists filter routes based on route and prefix length, while AS-Path
ACLs filter routes based on the ASN. Route maps can filter and set conditions, change attributes, and assign update policies.
NOTE: Dell EMC Networking OS supports up to 255 characters in a set community statement inside a route map.
NOTE: You can create inbound and outbound policies. Each of the commands used for filtering has in and out parameters
that you must apply. In Dell EMC Networking OS, the order of preference varies depending on whether the attributes are
applied for inbound updates or outbound updates.
For inbound and outbound updates the order of preference is:
● prefix lists (using the neighbor distribute-list command)
● AS-PATH ACLs (using the neighbor filter-list command)
● route maps (using the neighbor route-map command)
Prior to filtering BGP routes, create the prefix list, AS-PATH ACL, or route map.
For configuration information about prefix lists, AS-PATH ACLs, and route maps, refer to Access Control Lists (ACLs).
NOTE:
When you configure a new set of BGP policies, to ensure the changes are made, always reset the neighbor or peer
group by using the clear ip bgp command in EXEC Privilege mode.
Filtering BGP using IP prefix lists
An IP prefix lists contains a list of networks. When applying an IP prefix list to a BGP neighbor, you can able to send or receive
the routes whose destination is in the IP prefix list.
Filtering BGP routes based on IP prefix lists involves the following steps:
● Create a prefix list. The steps 1 to 3 in the following configuration commands shows how to create a prefix list.
● Applying the created prefix list to a BGP neighbor. The steps 4 and 5 show how the prefix list is applied to a neighbor.
To configure an IP prefix list, use the following commands.
1. Create a prefix list and assign it a name.
196
Border Gateway Protocol (BGP)