Setup Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced to all platforms.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage
Information
To enable OSPF on an interface, the network area command must include, in its range of addresses,
the primary IP address of an interface.
NOTE: An interface can be attached only to a single OSPF area.
If you delete all the network area commands for Area 0, the show ip ospf command output does not
list Area 0.
passive-interface
Suppress both receiving and sending routing updates on an interface.
S6000
Syntax
passive-interface {default | interface}
To enable both the receiving and sending routing, use the no passive-interface interface
command.
To return all OSPF interfaces (current and future) to active, use the no passive-interface
default command.
Parameters
default Enter the keyword default to make all OSPF interfaces (current and future)
passive.
interface Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
1056 Open Shortest Path First (OSPFv2 and OSPFv3)