Setup Guide

Parameters
interface Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For the Management interface, enter the keyword ManagementEthernet
then slot/port information.
● For a port-channel interface, enter the keywords port-channel then the
port-channel ID.
● For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14.1.0 The support for configuring management interface is introduced in S4810 and
S4820T.
9.13.0.0 Added support for configuring Management interface.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
ntp trusted-key
Set a key to authenticate the system to which NTP synchronizes.
Syntax
ntp trusted-key number
To delete the key, use the no ntp trusted-key number command.
Parameters
number Enter a number as the trusted key ID. The range is from 1 to 65534.
Defaults Not configured.
1568 System Time and Date