Setup Guide

IPv6 Access Control Lists (IPv6 ACLs)
IPv6 ACLs and IPv6 Route Map commands are supported on Dell EMC Networking OS.
NOTE: For IPv4 ACL commands, see Access Control Lists (ACL).
Important Points to Remember
● Certain platforms require manual CAM usage space allotment. For more information, see cam-acl.
● Egress IPv6 ACL and IPv6 ACL on the Loopback interface is not supported.
● Reference to an empty ACL permits any traffic.
● ACLs are not applied to self-originated traffic (for example, Control Protocol traffic not affected by IPv6 ACL because the
routed bit is not set for Control Protocol traffic and for egress ACLs the routed bit must be set).
● You can use the same access list name for both IPv4 and IPv6 ACLs.
● You can apply both IPv4 and IPv6 ACLs on an interface at the same time.
● You can apply IPv6 ACLs on physical interfaces and a logical interfaces (Port-channel/VLAN).
● Non-contiguous masks are not supported in source or destination addresses in IPv6 ACL entries.
● Because the prefix mask is specified in /x format in IPv6 ACLs, inverse mask is not supported.
Topics:
• show cam-acl-egress
• show cam-acl
• permit icmp
• permit
• ipv6 control-plane egress-filter
• ipv6 access-list
• cam-acl-egress
• cam-acl
show cam-acl-egress
Show information on FP groups allocated for egress ACLs.
S6000
Syntax
show cam-acl-egress
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
25
804 IPv6 Access Control Lists (IPv6 ACLs)