Setup Guide

mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a topology
change.
Syntax
mac-address-table station-move refresh-arp
To disable the ARP refresh feature, use the no mac-address-table station-move refresh-
arp command.
Defaults Enabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Modified the default option from none to Enabled.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
Usage
Information
For more information about using this command, see NIC Teaming in the Layer 2 section of the Dell EMC
Networking OS Configuration Guide.
mac learning-limit
Limit the maximum number of MAC addresses (static + dynamic) learned on a selected interface.
S6000
Syntax
mac learning-limit address_limit [vlan vlan-id] [station-move-violation
[dynamic]] [dynamic [no-station-move| station-move]]
Parameters
address_limit Enter the maximum number of MAC addresses that can be learned on the
interface. The range is from 1 to 1000000.
vlan vlan-id Enter the keyword then the VLAN ID. The range is from 1 to 4094.
Layer 2 887