Setup Guide

msti
Configure multiple spanning tree instance, bridge priority, and one or multiple VLANs mapped to the MST instance.
S6000
Syntax
msti instance {vlan range | bridge-priority priority}
To disable mapping or bridge priority, use the no msti instance {vlan range | bridge-
priority priority} command.
Parameters
msti instance Enter the MSTP instance. The range is from zero (0) to 63.
vlan range Enter the keyword vlan then the identifier range value. The range is from 1 to
4094.
bridge-priority
priority
Enter the keywords bridge-priority then a value in increments of 4096 as the
bridge priority. The range is from zero (0) to 61440.
Valid priority values are: 0, 4096, 8192, 12288, 16384, 20480, 24576, 28672, 32768,
36864, 40960, 45056, 49152, 53248, 57344, and 61440. All other values are
rejected.
Defaults default bridge-priority is 32768.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced.
Usage
Information
By default, all VLANs are mapped to MST instance zero (0) unless you use the vlan range command
to map it to a non-zero instance.
964 Multiple Spanning Tree Protocol (MSTP)