Users Guide

Version Description
6.1.1.0 Introduced on the E-Series.
ntp control-key-passwd
Configure control key password for NTPQ authentication. NTP control key supports encrypted and unencrypted option.
Syntax
ntp control-key-passwd [encryption-type] password
To delete the control key, use the no ntp control-key-passwd [encryption-type]
password command.
Parameters
encryption-type (OPTIONAL) Enter one of the following numbers:
● 0 (zero) directs the system to store the password as clear text. It is the default
encryption type when using the password option.
● 7 (seven) indicates that a password is encrypted using a DES hashing algorithm.
It specifies a hidden authentication data.
● WORD is the un-encrypted (cleartext) authentication data.
password Enter a string up to 32 characters as the password.
Defaults NTPQ
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Introduced on the S4810 and S4820T.
9.14(0.0) Introduced on the C9010, FN–IOM, MIOA, MXL, S3048–ON, S4048–ON, S4048T–
ON, S5048F–ON, S6000, S6000–ON, S6010–ON, S6100–ON, and Z9100–ON.
Usage
Information
NTP control key is not configured by default. If the encryption–type (0 or 7) is not specified, then 0 is
selected by default.
ntp disable
Prevent an interface from receiving NTP packets.
Syntax
ntp disable
To re-enable NTP on an interface, use the no ntp disable command.
Defaults Disabled (that is, if you configure an NTP host, all interfaces receive NTP packets)
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
1592 System Time and Date