Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1001

Table Of Contents

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

Usage

Information

To access this command, enter the class-map command. After the class map is identified, you can

configure the match criteria. For class-map match-any, a maximum of five ACL match criteria are allowed.

For class-map match-all, only one ACL match criteria is allowed.

Commands

class-map — identifies the class map.

match ip dscp

Use a differentiated services code point (DSCP) value as a match criteria.

Z9000

Syntax

match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp value]

To remove a DSCP value as a match criteria, use the no match {ip | ipv6 | ip-any} dscp

dscp-list [[multicast] set-ip-dscp value] command.

Parameters

ip Enter the keyword ip to support IPv4 traffic.

ipv6 Enter the keyword ipv6 to support IPv6 traffic.

ip-any Enter the keyword ip-any to support IPv4 and IPv6 traffic.

dscp-list

Enter the IP DSCP values that is to be the match criteria. Separate values by

commas — no spaces ( 1,2,3 ) or indicate a list of values separated by a hyphen

(1-3). The range is from 0 to 63.

set-ip-dscp

value

(OPTIONAL) Enter the keywords set-ip-dscp then the IP DSCP value. The

matched traffic is marked with the DSCP value. The range is from 0 to 63.

Defaults none

Command Modes CLASS-MAP CONFIGURATION (config-class-map)