Administrator Guide

Parameters
bandwidth Enter the keyword bandwidth to specify extended-community attribute as the
matching criteria for permitting traffic. The range is from 0 to 102400.
Defaults N/A
Command Modes EXTENDED COMMUNITY LIST
Command
History
Version Description
9.7(0.0) Introduced on the S-Series.
Related
Commands
deny bandwidth – link band width extended-community attribute as the matching criteria to deny
incoming or outgoing traffic..
redistribute
Redistribute routes into BGP.
Z-Series
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static} command.
Parameters
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static
Enter the keyword static to redistribute manually configured routes.
These routes are treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name of an established
route map.
Only the following ROUTE-MAP mode commands are supported:
● match ip address
● set community
● set local-preference
● set metric
● set next-hop
● set origin
● set weight
If the route map is not configured, the default is deny (to drop all routes).
Defaults Not configured.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Border Gateway Protocol 327