Manualshelf

Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9
41424344454647484950
Table Of Contents
Prompt Interface Type
Dell(conf-if-
range)#
Designated interface range (used for bulk configuration).
IP ACCESS LIST Mode
To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the ip access-
list standard or ip access-list extended command.
To enter IP ACCESS LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the ip access-list standard or ip access-list extended command. Include a name for the ACL. The
prompt changes to include (conf-std-nacl) or (conf-ext-nacl).
You can return to CONFIGURATION mode by using the exit command.
ISIS ADDRESS-FAMILY Mode
To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, refer to Intermediate System to
Intermediate System (IS-IS).
To enter ISIS ADDRESS-FAMILY mode:
1. Verify that you are logged in to ROUTER ISIS mode.
2. Enter the command address-family ipv6 unicast. The prompt changes to include (conf-router_isis-af_ipv6).
LLDP Mode
To enable and configure Link Layer Discovery Protocol (LLDP), use LLDP mode. For more information, refer to Link Layer
Discovery Protocol (LLDP).
To enter LLDP mode:
1. To enable LLDP globally, verify that you are logged in to CONFIGURATION mode. To enable LLDP on an interface, verify
that you are logged in to INTERFACE mode.
2. Enter the protocol lldp command. The prompt changes to include (conf-lldp) or (conf-if-interface-lldp).
LLDP MANAGEMENT INTERFACE Mode
To enable and configure Link Layer Discovery Protocol (LLDP) on management interfaces, use LLDP MANAGEMENT
INTERFACE mode.
To enter LLDP MANAGEMENT INTERFACE mode:
1. Verify that you are logged in to LLDP mode.
2. Enter the management-interface command. The prompt changes to include (conf-lldp-mgmtIf).
LINE Mode
To configure the console or virtual terminal parameters, use LINE mode.
To enter LINE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the line command. Include the keywords console or vty and their line number available on the switch. The prompt
changes to include (config-line-console) or (config-line-vty).
You can exit this mode by using the exit command.
CLI Basics
47