Administrator Guide

Interfaces
The commands in this chapter are supported by Dell Networking operating software on the Z9000 platform.
This chapter contains the following sections:
● Basic Interface Commands
● Port Channel Commands
● Time Domain Reflectometer (TDR)
● UDP Broadcast
Topics:
• Basic Interface Commands
• Egress Interface Selection (EIS) Commands
• Port Channel Commands
• Time Domain Reflectometer (TDR)
• UDP Broadcast
• Enhanced Validation of Interface Ranges
• ip http source-interface
Basic Interface Commands
The following commands are for Physical, Loopback, and Null interfaces.
clear counters
Clear the counters used in the show interfaces commands for all virtual router redundancy protocol (VRRP) groups, virtual local
area networks (VLANs), and physical interfaces, or selected ones.
Z9000
Syntax
clear counters [interface] [vrrp [ipv6 {vrid} | learning-limit | vlan vlan-
id]
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/port or number to clear
counters from a specified interface:
● For IPv4 access-group counters, enter the keyword ip.
● For IPv6 access-group counters, enter the keyword ipv6.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For MAC access-group counters, enter the keyword mac.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For the management interface on the RPM, enter the keyword
ManagementEthernet then slot/port information. The slot range is from 0
to 1 and the port range is 0.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
21
496 Interfaces