Administrator Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage
Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are not assigned to an IP address or
switchport. To place an interface in Layer 2 mode, ensure that the interface’s configuration does not
contain an IP address and enter the switchport command.
You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface with no default
configuration. To delete a tunnel interface, use the no interface tunnel tunnel-id command.
The tunnel interface operates as an ECMP (equal cost multi path) only when the next hop to the tunnel
destination is over a physical interface. If you select any other interface as the next hop to the tunnel
destination, the tunnel interface does not operate as an ECMP.
Example
Dell(conf)#int tengigabitethernet 1/10
Dell(conf-if-te-1/10)#exit
Dell(conf)#
Related
Commands
interface loopback — configures a Loopback interface.
interface null — configures a Null interface.
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
show interfaces — displays the interface configuration.
interface group
Create or delete group of VLANs with a single command. You can also use this command to apply a set of configurations on a
group of interfaces.
Z9000
Syntax
interface group [fortyGigE slot/port { - port }| tengigabitethernet slot/
port { - port } | vlan vlanid {- vlanid } ]
To delete a range of VLANs, use the following command: no interface group vlan vlanid {-
vlanid}
Parameters
interface,
interface,...
Enter the keywords interface group and one of the interfaces — slot/port or
VLAN number. Select the range of interfaces for bulk configuration. Spaces are not
required between the commas. Comma-separated ranges can include VLANs and
physical interfaces.
Enter the member VLANs using VLAN IDs (separated by commas), a range of
VLAN IDs (separated by a hyphen), a single VLAN ID, or a combination. For
example: VLAN IDs (comma-separated): 3, 4, 6. Range (hyphen-separated): 5-10.
Slot/Port information need not contain a space before and after the
dash. For example. both of the following commands are valid: interface
Interfaces 505