Administrator Guide

Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
If the flowlabel value is already set for BGP or SSH, the system defaults to the already configured
value. All packets on the same connection are considered part of the same flow by the system. For new
connections, set the new flowlabel to zero.
ipv6 host
Assign a name and IPv6 address the host-to-IPv6 address mapping table uses.
Z9000
Syntax
ipv6 host name ipv6-address
To remove an IP host, use the no ipv6 host name {ipv6–address}.
Parameters
name Enter a text string to associate with one IP address.
ipv6-address Enter the IPv6 address (X:X:X:X::X) to be mapped to the name.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.1.0 Introduced on the E-Series TeraScale.
ipv6 name-server
Enter up to six IPv6 addresses of name servers. The order you enter the addresses determines the order of their use.
Z9000
Syntax
ipv6 name-server ipv6-address [ipv6-address2... ipv6-address6]
IPv6 Basics 649