Administrator Guide

Field Description
Incoming
interface
Displays the reverse path forwarding (RPF) information towards the source for
(S,G) entries and the RP for (*,G) entries.
Outgoing
interface list:
Lists the interfaces that meet one of the following:
● a directly connected member of the Group
● statically configured member of the Group
● received a (*,G) or (S,G) Join message
Example
Dell#show ip mroute
IP Multicast Routing Table
(*, 224.10.10.1), uptime 00:05:12
Incoming interface: TenGigabitEthernet 3/12
Outgoing interface list:
TenGigabitEthernet 3/13
(1.13.1.100, 224.10.10.1), uptime 00:04:03
Incoming interface: TenGigabitEthernet 3/4
Outgoing interface list:
TenGigabitEthernet 3/12
TenGigabitEthernet 3/13
(*, 224.20.20.1), uptime 00:05:12
Incoming interface: TenGigabitEthernet 3/12
Outgoing interface list:
TenGigabitEthernet 3/4
show ip rpf
View reverse path forwarding.
Z9000
Syntax
show ip rpf
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
E-Series legacy
command
Usage
Information
Network administrators use static mroutes to control the reach-ability of the multicast sources. If a
PIM-registered multicast source is reachable using static mroute as well as unicast route, the distance of
each route is examined and the route with shorter distance is the one the PIM selects for reach-ability.
Multicast 815